82 channels are not available on the 3100 !!!! Tells my wife senior support will call me a 7:15, no one ever called back and that's was probably a good thing!! Frigging incredible I say!!!! Then proclaims to my wife that the 91 are both defective and the 3100 is working fine, even though sat. Tells my wife that the COAX to the upstairs 9141 had a short in it (this MIGHT be the only thing correct I don't know). And to add insult to injury this AHOLE disconnected and moved cabling around for my Shaw Internet and Phone, so they where dead when I got home!!!

Then split the single signal feeds using a DPP separator to the 91.ĭisconnected a bunch my stereo equipment. Neither the 9142 or 9141 is working at all (but he said the old 3100 is working,but only off Sat.82), he took my DPP44 switch home with him and direct wired all 4 lines off the DP Quad LNB, tried to tell my wife it wasn't needed. and I come home to a 3 hour service call that my wife signed. Got home last night and I was so MAD that I was fit to be tied!! If I sound frazzled it's because I have to head out again today so I've not slept well either.īell sent it's best out to fix the problem on Sat. Sorry guys I had to head out to work for a few days so I couldn't reply and am gone for another week tonight. If I get Bell to send out a tech will he say there is nothing he can do once he finds I'm running DPP equipment? No problem with SD programming.Īny ideas anyone, I've checked all the cables and both receivers are doing the same thing.

I can usually watch my HD channels it's just very finicky and frustrating when I change to another HD channel, there's a 50/50 chance it will work. And when I get the 004 error and hit OK the channel will sometimes work right away other times a few minutes later and still other times just won't work. So then I'll go to an HD channel like Oasis and it works? It will work 50% of the time. Test switch is OK for 38 of 38 transponders on input 1 (trans.82)but input 2 can't find anything, at the end I get the error 'warning the check switch has found you have fewer sats than previously detected'. Not getting a signal on 'point dish Sat.91' although if I browse through the transponders I'll occasionally get a good signal on a transponder. Eventually channels will connect and have never lost a signal while on any given HD channel. Will go to change a channel and get a 044 error on screen. In the last couple of weeks I've been having problems with HD channels(ever since Bell upgraded my channel lineup for less cost?). Had this setup for a number of years now. Equipment Quad DPP LNB, DPP44, DPP Separator to the 9141 & 9142 revicers.

Dish pro plus quad lnb installation